Also included on the 2800 are four
traditional, hard-wired sensor inputs. These are Sensaphone Universal
Inputs that can be used with temperature sensors, dry contact sensors,
and even 4-20mA transducers. So, when you have monitoring requirements
near the 2800, just wire them in. When wiring is inconvenient or further
away, just stick the wireless sensors where you need them. The wireless
sensors will operate up to 300 feet line-of-site* away from the 2800.
Not far enough? Just add a wireless repeater to go farther. The repeater
can be located up to 4000 feet line-of-site* from the 2800. Then, one or
more sensors can be located up to 300 feet line-of-site* from the
repeater.
Notification
Just like the other Sensaphone products,
the 2800 uses the reliability of a standard phone line to make phone
calls to the appropriate personnel to announce alarm conditions. Each
monitoring condition, both wired and wireless, can have a custom voice
message attached to
it. Each message is recorded in your own voice for easy alarm
identification. Alarm notification will repeat out to eight people until
acknowledged.
Applications
Use the 2800 to monitor multiple
greenhouses without wires, multiple barns, coolers, freezers, or a wide
variety of remote equipment. The new Sensaphone 2800 can be used
anywhere you would use our other Sensaphone products. The 2800 just
makes installation and expansion faster and easier. Extend your reach
and monitor your critical remote locations with the new Sensaphone 2800.
|