Now you can monitor critical conditions at
remote locations without running wires. Introducing the new Sensaphone
2800 with Wireless Sensor Technology.
Based on proven Sensaphone remote
monitoring methods, the 2800 adds the ability to read sensor status from
wireless sensors. And not just simple on/off status, or open/closed
conditions. The Sensaphone Wireless Technology includes full analog
capability so real world values can be monitored, like actual
temperatures, real tank levels and flow rates.
You can use up to four of the Sensaphone
wireless sensors with the 2800. A variety of wireless sensors types are
available to choose from, including ...
Temperature
Humidity
Power Failure
Motion Detector
Water on Floor
In addition to the wireless sensors,
there are also two Wireless Interface modules. These allow you to
connect to existing equipment or sensors and transmit their status back
to the 2800 wirelessly. There is a Dry Contact wireless module, and even
a 4-20mA wireless module. The 4-20mA wireless module even provides
battery backed 24 VDC loop power for your transducer.
Stick It Anywhere!
Most of the Sensaphone Wireless Sensors
run on batteries for up to 3 years. You can literally, just stick a
sensor to the wall and start monitoring right away. The 2800 will scan,
find the sensor, self configure and do most of the work for you. All you
need to do is to record a custom voice message and fill in a few
parameters.
Self Diagnostics
The Wireless Sensor Network is always
being watched by the 2800. In addition to looking for alarms from the
sensor values, it is also looking to make sure that each wireless sensor
is fully functional and its batteries are full. If there are any
problems with the wireless sensors, the 2800 will initiate a diagnostic
alarm and notify the appropriate personnel immediately.